Installing The Umbrella Holder; Dismantling Procedure; Adjusting The Front Wheel/Going Forward - Leisure Golf Taurus Notice D'utilisation

Installing the umbrella holder

There are two ways to install the umbrella holder.
The first and fastest option (Fig. 1) is to take the umbrella holder complete with
clamp and screw and slide it sideways onto the pin (A). Then turn the umbrella
holder clockwise until the clamp is clamped onto the pin (B).
The second option (Fig. 2) is recommended in strong winds. To do this, loosen
the Phillips-head screw on the umbrella holder and turn down the clamp.
Now you can screw the umbrella holder vertically into the threaded hole on
the side of the grip pin.
1 2
B
A

Dismantling procedure

1. Take the supplied socket wrench and press the spring button into the fra-
me. Turn the rod slightly so that the knob cannot spring back and pull the
linkage apart.
2. Repeat the same steps you have with the rod that
leads to the front wheel. By pressing and slightly
turning the linkage, the lock can be easily released.
3. Pull the wheels off the axle by pressing the pin on
the rim.
If you have ordered the trolley bag, you can optimally
stow all components in the bag.
26

Adjusting the front wheel/going forward

With each trolley, the factory preset is straight travel.
Nevertheless, it may be necessary to readjust the barrel.
1. Loosen the cap nut one or two turns.
2. If the device is pulling to the left, unscrew the front grub screw and
screw in the rear grub screw.
3. If the device is pulling to the right, unscrew the rear grub screw and
screw in the front grub screw.
4. Then tighten the cap nut again.
5. You may have to readjust the setting with a second pass.
Grub screw
Cap nut
27
Front grub screw
Rear grub screw