Installing The Wheels, Handlebar And Battery; Installing The Scorecard Holder - Leisure Golf Taurus Notice D'utilisation

Installing the wheels, handlebar and battery

1. Take the axle in your hand and connect it to the front part. Slide the front
part up to the pin in the opening of the lateral axle.
Press the stainless steel pin into the frame and push the front part com-
pletely into the lateral axle. Turn the two parts together so that the pin can
engage into the hole.
2. Take the rear wheels and install them on the lateral axle as described below.
Danger: Pay attention to the running direction of the rear wheels. The profile
must point in the same direction as the front wheel profile.
- Press the pin on the rim.
- Slide the wheels onto the first groove on the axle. This is the freewheel posi-
tion (for manual pushing).
- Push the wheel to the final position on the axle and engage. This is the posi-
tion for driving.
Important: If the wheel is not in the drive position, there is no propulsion of
the device.
3. Now connect the vertical bar with the lateral axle. Proceed in the same way
as above.
4. With the side knob, you can adjust the handle height and 'adjust' the upper
bag holder individually to your bag size. Then tighten the lateral fixing screw.
5. Attach the battery to the front frame with the two Velcro straps and connect
the battery to the battery connector on the golf trolley. The LED on the control
panel will flash blue.
24

Installing the scorecard holder

Open the basic holder by loosening both screws with the hex key which has been sup-
plied. Place the basic holder on the top bar as shown in the picture and attach it with the
counterpart and the two screws.
Pay attention to the correct position of the hole pattern, matching the scorecard holder.
Then screw the scorecard holder onto the basic holder. For this purpose, a hex key has
also been included.
25