Adaptec 1405 Guide De Démarrage page 7

Step 3 Creating the Driver Disk
Before you install the driver, you need to create a driver disk. To create the
driver disk:
Insert the Adaptec Controller CD and power on the computer to boot
a
from the CD.
Follow the on-screen instructions to display the CD menu.
b
Click Create Driver Disk, and select the required operating system.
c
When prompted, insert a floppy disk, then click OK. The computer
d
creates the driver disk.
Remove and label the driver disk.
e
Continue with the installation of the operating system and controller
f
driver.
Step 4 Installing the Controller Driver with
the Operating System
Windows 2003/XP
Insert the Windows CD, and restart the computer.
a
When prompted to install a third-party driver, press F6.
b
Note: When F6 is active, a prompt appears at the bottom of the screen
for only 5 seconds. If you miss your chance to press F6, restart your
computer.
Insert the driver disk, then wait until prompted to install the driver.
c
Press S to specify that the driver is on the floppy disk, then press Enter.
d
The computer reads the disk.
When the driver is found, press Enter. Follow the on-screen
e
instructions to complete the installation.
Windows Vista/Windows Server 2008
Insert the Windows CD.
a
When prompted to install a third-party driver, click Load Driver.
b
Browse to locate the driver and click Next to proceed with the
c
installation.
3