Adaptec 1405 Guide De Démarrage page 6

Step 1 Installing the Controller
Caution: Electrostatic Discharge (ESD) can damage your SATA/SAS
!
controller. Handle the controller carefully so that you do not expose it
to static charge.
If you have a low-profile computer cabinet, replace the original full-
a
height bracket on the controller card with the low-profile bracket
supplied in the controller kit.
Turn off your computer and disconnect the power cord.
b
Open the system cabinet.
c
Remove the cover from an available PCIe slot.
d
Install the controller in the PCIe slot and secure the controller bracket
e
to the chassis.
Connect the SATA/SAS controller's I2C connector (not available on all
f
models) to an I2C connector on an internal backplane or enclosure,
using an I2C cable.
Install and connect any internal disk drives using the appropriate
g
cable(s), then close the computer cabinet.
All connectors are keyed so that you can insert the cables in only
●
one direction.
Do not try to force a cable in to the controller or a disk drive. If the
●
connector does not slide on easily, try reversing it.
Step 2 Setting Up the Boot Sequence
The process you use to access your computer's BIOS Setup program and
set the boot sequence varies by the computer manufacturer. Refer to the
instructions provided with your computer. The steps may be similar to:
During startup, press the key combination (for example, <F2>, <F1>,
a
<DEL>) that starts the BIOS Setup program.
Go to the menu used to specify the boot sequence. Put the CD drive
b
first—this allows you to perform Step 3 below.
Go to the menu used to specify the boot priority for disk drives. Put
c
the controller first in this sequence.
Save your changes, exit Setup, and then restart your computer.
d
2