Armrests; Backrest Extension; Headrest - Grammer ACTIMO EVOLUTION Mode D'emploi

Seat functions and operation
** depending on model
28

Armrests

The armrests can be folded up if required and
the height individually adjusted.
To adjust the armrests for height, separate
the round cap (see arrow) from the cover,
loosen the hexagon nut (size 13 mm) behind
it and adjust the armrests to the desired
position
(5-steps) and tighten the nut
again (25Nm). Press the cover cap back into
929
the cover.

Backrest extension **

The backrest extension can be individually
adjusted for height by pulling it upwards over
the various increments up the end stop.
To remove the backrest extension, pull it
upwards over the end stop.
931

Headrest **

The headrest can be individually adjusted for
height by pulling it upward over the various
increments up the end stop.
By pushing foreward or rearward the angle of
the headrest can be adjusted individually.
To remove the headrest, pull it upwards over
the end stop.
GB