Getting Started - XciteRC Dragon250 Mode D'emploi

Binding
ATTENTION: before the first flight of the Race-Copter must be bound to the transmitter.
EN
• Place the battery into the battery compartment and connect the plug. The green LED in the battery com-
partment starts flashing.
• Then immediately turn on the transmitter. After 1-3 seconds, the green LED in the battery compartment
lights permanently, the binding was successful.
• If the green LED in the battery compartment still flash, repeat the procedure.
RC functions (Mode 2)

Getting started

Before you begin please check:
• WARNING: Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the flying qualities.
24
Binding · RC functions · Getting started
XciteRC Dragon 250