Traxxas 3737 Instructions D'installation

Camber Link Instructions
Installing the Hollow Balls
Use pliers to install the hollow
balls into the rod ends. Place the
hollow ball onto the rod end and
squeeze the pliers until the
hollow ball snaps in. Refer to the
illustrations to the right for correct
installation. Remember to always
wear safety glasses.
If you have any questions or need
technical assistance, call:
1-888-TRAXXAS
(1-888-872-9927) (U.S. residents only)
E-mail: support@Traxxas.com
Slash Rear Left Camber Link
Slash Only - Link must be adjusted to be 72.5mm
Outer
Slash Rear Right Camber Link
Slash Only - Link must be adjusted to be 72.5mm
Inner
*The link without rod ends is 39mm long.
Traxxas, 1100 Klein Road, Plano, TX 75074, Phone: 972-265-8000, Fax: 972-265-8011
Front Left Camber Link
Rustler / Stampede / Slash
Mounts to Axle Carrier
Outer
Front Right Camber Link
Rustler / Stampede / Slash
Inner
(actual size)
72.5mm*
Mounts to Axle Carrier
(actual size)
72.5mm*
Mounts to Axle Carrier
w w w . T R A X X A S . c o m
(actual size)
69mm*
(actual size)
Mounts to Axle Carrier
69mm*
Covers Part #3737, 3737A
Inner
Outer
Inner
Outer
KC1055 Rev. 121011