Arrow MiniPlus Gun Mode D'emploi page 4

SAFETY PRECAUTIONS: WARNING!
• Do not touch heated nozzle or melted glue –
touching any heated portions of the product may result
in personal injury, such as a burn. Operating temperature
of the nozzle is 380˚F (193˚ C).
• When glue is hot do not lay glue gun on its side always
use stand.
• Property damage and personal injury may result from
extended contact with tip of hot glue gun.
• Place the glue gun in the upright position when idle using
the base stand provided or fold wire stand down for
placement outside of base stand.
• Do not leave unattended.
• For general indoor household use only and should not be
used for outdoor or industrial purposes.
• Do not use near water, liquids or rain.
• Do not use this product in areas where the risk of explosion
is present.
• USE ONLY RECOMMENDED ATTACHMENTS. Use of an
attachment not recommended or sold by the manufacturer
may result in a risk of fire, electric shock or personal injury.
• UNPLUG POWER CORD when not in use.
• Turn off glue gun by placing the switch to the OFF
position (o) (UP) and unplug glue gun or base stand
when not in use.
4
GENERAL TOOL SAFETY WARNINGS
• Allow glue gun to cool before storing.
• Do not try to remove unused portion of glue sticks from
glue gun after use.
• Do not use a damaged glue gun.
• Do not disassemble or attempt to repair this appliance –
service must be performed only by an authorized service
representative.
• Children shall not play with appliance. However, this
appliance can be used by children aged 8 and above, as
well as by person with reduced physical, sensory or mental
capabilities, provided that they are supervised and are
instructed about using the appliance in a safe way and
understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by
children without supervision.
• Keep away from children under the age of 8 and animals.
• Do not carry the tool by the cord or pull cord to disconnect
it from the outlet.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similar qualified persons
in order to avoid hazard.