Inoksan BYM042B Mode D'emploi page 10

USING THE MACHINE

 6.1- Running
1. READY
2. ON/OFF
3. P1 : 1. short program 80 sec
4. P2 : 2. medium program 110 sec
5. P3 : 3. long program 140 sec
6. DRAIN
 P1-Short Wash (80 sec) : For dishes with low
dirt
 P2-Medium Wash (110 sec) : For dirty dishes
 P3-Long wash (140-180 sec.) : For oily and
dirty dishes
You can select one of the programs "P1, P2 and
P3". Recommended washing duration is 110 sec.
and recommended water temperature is 55ºC.
At the start of operation, when the temperature
reaches 55ºC, "washing temperature reached
signal light" turns on. After the light turns on, an
appropriate program is selected. As long as the
When you are sure that the water drained
completely, turn off the machine.
The full model includes a top level
pressurestat.
When the water level reaches above the spill
level, the bilge pump runs and automatically
drains for a certain amount of time. This
running continues until the contacts of the
pressurestat relocates.
1. Select the relevant tray according to the dishes
to be washed and load them according to the
capacities stated on the chart. Do not start the
device without entirely filling the tray in order
to save detergent and power.
2. Never change the location of the device while
it is operating.
3. Be sure that the water input valve is open
before operating the device.
WARNING!!!
ATTENTION: In that position, when the dial is
turned to P1, that will start the washing, however
the detergent foams because the cold water.
the best result of the washing process, the signal lamp
of "the washing temperature is ready" should be
waiting.
washing continues, the "in wash" signal light stays
on.
DRAINING:

Lid opens

Stopper is removed

ON "ON / OFF" button numbered 2 is
turned off.

Press the "DRAIN" button number 6
once.

Tah Evacuation of the device begins

light While draining is in progress, the
DRAIN button is on, the light goes out
when the process is finished.
NEVER PUT YOUR BARE HANDS IN THE WASH
WATER. IF NECESSARY, USE PROTECTIVE
GLOVES. DO NOT RUB DETERGENT WATER ON
YOUR EYES.
9. TURNING OFF
1. Press the "2 ON / OFF" button of the
machine.
2. Bring the switch that supplies the device to
"0" position.
3. Take the washed product out by lifting the
upper cover and close the cover.
4. Close the water inlet valve.
10.SECURITY MEASURES
1. If the cover is opened while the device is
operating or if the cover is not completely
closed after it is started, the device will stop
operating. Device will start operating once the
cover is shut.
10
For