Routine Maintenance; Basic Safety Standards For Machine Maintenance - Berkel BV 400/25 Mode D'emploi

Instruction manual for vacuum chamber packaging machines Mod. BV 400/25 – BV 400/25H – BV 600/60 Instruction manual for vacuum chamber packaging machines Mod. BV 400/25 - BV 600/60
Rev. 01 - 04/2019 - Cod. 1500656 - Instruction manual for vacuum chamber packaging machines Mod. C46-C46H-C62
Implementing the scheduled maintenance regularly, as described further on in this manual, minimises and/or
eliminates potential faults and interference and increases the machine lifetime significantly.
Failure to perform regular maintenance can lead to significant repair costs, and in certain cases, render the
guarantee null and void.
Furthermore, a good standard of hygiene is maintained if that indicated is complied with
7.1 BaSIC SaFeTy STaNDaRDS FOR MaChINe MaINTeNaNCe
To carry out cleaning and routine maintenance operations safely, follow the regulations provided below:
ElECTrICal HaZard! If the power supply cable is damaged, it must be replaced by the ma-
nufacturer or an authorized service center.
ElECTrICal HaZard! The power sources must be disconnected before cleaning, disinfecting, per-
forming maintenance and/or repairing any component of the appliance (Disconnect the electrical plug
from the mains).
daNgEr! It is strictly prohibited to remove the guards and safety devices to perform routine
maintenance. The manufacturer declines all liability for accidents due to non-compliance with
the above-mentioned obligation.
aTTENTIoN!
always use suitable preventive measures and protective devices (gloves, etc.) for any
maintenance, handling, installation and cleaning operations.
warNINgS!
• Only qualified technicians must perform maintenance or access live parts of the machine.
• Contact a Technical Support Centre authorised by the manufacturer for any repairs. Only original
spare parts must be used and requested.
• Do not perform maintenance yourself where the intervention of a qualified technician is indicated in
the manual.
• Do not touch the machine with bare, damp or wet hands or feet.
• Do not insert screwdrivers, kitchen instruments or anything similar between the guards, openings
and moving parts of the machine.
• When work is complete, detach the piston by pushing it toward the rear and lower the lid to the resting
position. This protects the vacuum chamber from dust and dirt.
28

7. rouTINE MaINTENaNCE