Russell Hobbs 19810-56 Mode D'emploi page 66

Read the instructions, keep them safe, pass them on if you pass the appliance on.
Remove all packaging before use.
A IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This appliance must only be used by or under the supervision of a responsible adult. Use and
store the appliance out of reach of children.
2 Use this attachment only with product number 18553-56.
3 Keep your hands away from the blades – they're sharp
4 Don't use fingers or cutlery to push food down the tube – only the pusher.
5 Don't use the appliance for any purpose other than those described in these instructions.
6 Don't run the motor continuously for more than 10 minutes, it may overheat. After 10
minutes switch off for at least 10 minutes, to recover.
7 Unplug the appliance before fitting or removing attachments.
8 Don't operate the appliance if it's damaged or malfunctions.
C ASSEMBLY
1 Push the shaft into the body.
2 The rear of the shaft should stick out about 14mm from the rear of the body.
3 Fit the blade to the front of the shaft.
4 The flat side of the blade should be towards the screen.
5 Fit the screen you want to use.
6 The slot in the edge of the screen fits over the lug inside the front of the body.
7 Fit the ring nut to the front of the body and tighten it by hand.
8 Don't use excessive force, you'll damage the threads.
9 Switch the appliance off (0) and unplug it.
10 Open the front drive cover.
11 Pull the catch down, and hold it there.
12 Push the rear of the body into the front drive on the appliance.
13 You may have to rotate it to fit the rear of the shaft into the drive.
14 When the drive is correctly located, rotate the body till the tube is vertical.
15 Release the catch – it should locate in the hole under the body rear.
16 Fit the tray into the tube.
17 Fit the cap to the pusher, and drop the pusher into the tube.
18 Put the bowl under the end of the grinder, to catch the ground meat.
19 The bowl can be inverted and used to cover the tray.
C GRINDING
20 Cut meat into strips 25mm square and set them on the tray.
21 Put the plug into the power socket.
22 Select speed 4 or above.
23 Remove the pusher, and drop the ingredients down the tube.
24 Replace the pusher, and use it to push the ingredients gently down the tube.
25 When you've finished, run scraps of bread through the grinder to clear the screen.
26 Switch the appliance off (0) and unplug it.
C WHICH SCREEN?
27 Use the fine screen to grind raw meat for ground meat or meatballs, and citrus peel.
28 If you need an extra-fine grind, for sausages or pâté, put the meat through the grinder again.
29 Use the coarse screen to grind raw meat for burgers.
30 When grinding anything else, use whichever screen gives the size you want.
household use only
66