Publicité
Les langues disponibles
Les langues disponibles
Maintenance Procedures
A written log of all service and inspection dates for this
equipment should be maintained by the company
safety officer or other competent individual.
1.
Clean and maintain equipment as recommended.
Wash in warm water and mild detergent. Avoid harsh
chemical agents such as degreasing compounds, tur-
pentine, paint thinner, gasoline, and other solvents.
General Inspection Procedures
1.
Check for wear and deterioration. Before each
use, carefully inspect your OPE equipment for signs
of wear or deterioration or evidence of impact load-
ing. Visually inspect for loose threads, pulled rivets,
burns, cuts, abrasions, or evidence of chemical or
physical deterioration that may have weakened the
material or assembly.
2.
Inspect hardware for malfunctions and cracks,
including belt buckles, D-rings, and positioning-strap
snap hooks. Check that snap hooks are not distorted
or cracked and that the keepers are free of burrs,
functioning properly, clean, and not bent.
KL Style Shown
3.
Destroy
and
damaged equipment. Immediately destroy and
replace any OPE system component which does not
pass inspection.
8
replace
all
worn
2.
Inspect and lubricate all snap hooks after
cleaning to make sure they operate properly and
close securely. Use an all-purpose spray lubricant
or light motor oil.
3.
Maintain leather parts with Neat's-foot oil, saddle
soap or equivalent to help prolong life. Let leather
dry slowly at room temperature.
Should any unusual conditions be
noted during the inspection which are not speci-
fied here, do not use the suspect equipment
until a qualified individual has made a decision
on its usability.
or
Publicité
