Publicité
I N STALLATI ON GUI DE
2
Wiring
Terminal
Description
P1-1
Beeper Input (BEEP)
P1-2
LED Input (GRN)
P1-3
Ground (GND)
P1-4
+VDC
P1-5
Unused (DRAIN)
P1-6
LED Input (RED)
P1-7
Hold Input (HOLD)
*Tamper Output - When activated, output synchronizes to ground (default).
**Dependent upon reader configuration. See the HTOG for Wiegand and Clock-in-Data configurations.
This Installation Guide is for informational purposes only. HID makes no warranties, expressed or implied, in this summary. Company, product names and data used in sample output
are fictitious. Specifications are subject to change without notice.
© 2014 - 2015 HID Global Corporation/ASSA ABLOY AB. All rights reserved. HID, the HID logo, and iCLASS SE are trademarks or registered trademarks of HID Global in the U.S.
and/or other countries. All other trademarks, service marks, and product or service names are trademarks or registered trademarks of their respective owners.
h id g l o b a l.co m
Terminal
Description
P2-1
GPIO4 (RS485-Y / TXA)
P2-2
GPIO3 (RS485-Z / TXB)
P2-3
**Wiegand Data 0 / Data (DATA0/DATA)
P2-4
**Wiegand Data 1 / Clock (DATA1/CLK)
P2-5
*Open Collector Output / Tamper (OC/TMPR)
P2-6
GPIO2 (RS232-R / RS485-RXB)
P2-7
GPIO1 (RS232-T / RS485-RXA)
An ASSA ABLOY Group brand
iCLASS SE
U90 (U90.915 & U90.865) PLT-01545 A.2
Page 3
ATTENTION
Observe precautions for handling
ELECTROSTATIC SENSITIVE DEVICES
Terminal
Description
P3-1
Earth Ground
P3-2
Normally Closed (NC) - Relay 1
P3-3
Common (COM) - Relay 1
P3-4
Normally Open (NO) - Relay 1
P3-5
Normally Closed (NC) - Relay 2
P3-6
Common (COM) - Relay 2
P3-7
Normally Open (NO) - Relay 2
P3-8
Normally Closed (NC) - Relay 3
P3-9
Common (COM) - Relay 3
P3-10
Normally Open (NO) - Relay 3
Publicité
