Safety Index; Troubleshooting - Omega MeGo PBL1000BD Mode D'emploi

SAFETY INDEX

CONTINUOUS OPERATING TIME
TROUBLE SHOOTING
PROBLEMS
MOTOR DOESN'T
START OR
ATTACHMENT
DOESN'T ROTATE.
FOOD IS UNEVENLY
CHOPPED
FOOD IS TOO
FINELY CHOPPED
OR TOO WATERY.
CUP IS LEAKING.
UNIT DOESN'T
TURN ON.
UNIT DOESN'T
TURN OFF.
DOESN'T MIX WELL.
LID/BLADE AS-
SEMBLY WILL NOT
PROPERLY ALIGN
TO THE CUP.
The above mentioned contents are common fault analysis and troubleshooting,
for others, please contact our company Customer Service Department.
RATED VOLTAGE
RATED POWER
RATED FREQUENCY
POSSIBLE REASONS & SOLUTIONS
FOR THE CUPS, MAKE SURE THAT THE TABS ARE SEATED IN THE SLOTS
AND TURNED CLOCKWISE.
EITHER YOU ARE CHOPPING TOO MUCH FOOD AT ONCE, OR YOU ARE
NOT PULSING PROPERLY. REDUCE THE AMOUNT OF FOOD IN THE CUP.
THE FOOD HAS BEEN OVER PROCESSED. USE SHORT PULSES FOR
BEST RESULTS. PRESS DOWN ON THE CUP.
MAKE SURE THAT YOUR LID OR BLADE ASSEMBLY IS PROPERLY ASSEMBLED
TO THE CUP. LEAKING MAY OCCUR IF IT IS MISALIGNED WHEN TWISTED
ONTO THE CUP. TURN THE LID.
MAKE SURE THE UNIT IS PLUGGED IN.
ROTATE AND PRESS DOWN ON THE CUP TO TURN THE UNIT ON.
MAKE SURE THE BLADE ASSEMBLY IS PROPERLY ASSEMBLED TO THE
CUP AND THAT IT IS NOT MISALIGNED
UNPLUG THE POWER CORD FROM THE ELECTRICAL OUTLET AND CALL
CUSTOMER SERVICE FOR SUPPORT.
PULSE INGREDIENTS FOR BEST RESULTS. PRESS DOWN ON THE CUP IN
SHORT INTERVALS FOR EVEN BLENDING AND CHOPPING. FOR FROZEN
INGREDIENTS, PULSE IN SHORT INTERVALS OF 2-5 SECONDS AND REPEAT.
SET THE CUP ON A LEVEL SURFACE. PLACE THE LID OR BLADE ASSEMBLY ON
TOP OF THE CUP AND ALIGN THE THREADS SO THAT THE LID/BLADES SIT FLAT
ON THE CUP. TWIST CLOCKWISE SO THAT THE LID/BLADES EVENLY ALIGN TO
THE CUP UNTIL YOU HAVE A TIGHT SEAL.
Customer Service: 1-800-633-3401
Online: www.OmegaJuicers.com/contact-omega-juicers
CONTACT US:
120V~
1000W
60HZ
≤45 Seconds
10