Getting Started; Assembling Your Steam Pocket Mop - Sharp Klik n' Flip SMARTRONIC DELUX S6003EU Notice D'utilisation

Getting Started

When assembling your Steam Mop there may be a little water in or around the water tank. This is because we test all our
Steam Mops before you buy them, so you get a quality Shark
j
k
m
n
a
Steam Mop Handle
b
Quick-Release Cord Holder
c
Cord Management Clip
d
Filling Flask (clips to Steam Mop pole)
e Steam Mop Pad Release Button
f Steam Mop Body
g Water Tank Lid
34
Klik n' Flip Smartronic Deluxe Steam Pocket
®
a
b
c
d
e
f
g
h
i
l
h
Steam Control Button
i
Water Tank
j
Mop Head Release Button
k
Secondary Release Buttons
l Steam Blaster Nozzle
™
m Klik n' Flip Mop Head
n Dirt Grip Pad (x2)
™
Assembling Your Steam Pocket
Mop.
®
fig. 1
WARNING: Always make sure the Steam Mop
is UNPLUGGED when not in use. Never fill the
Steam Mop or attach the mop head when
the Steam Mop is plugged into an electrical
outlet. Unplug from the electrical outlet and
allow to cool before you fill the Steam Mop,
or attach or remove the head. To prolong the
life of your Steam Mop, we recommend using
distilled water. Make sure you add only water
to the tank. Chemicals or cleaning solutions
(including vinegar) may damage the Steam
Mop and could be unsafe for you and your
family.
STEAM MOP ASSEMBLY
1
Insert the Steam Mop handle into the Steam Mop
body. Push the handle in until you hear it click into
place. (fig. 1)
2
Slide the Klik n' Flip Mop Head into the Steam Mop
body. Push until you hear it click securely into place.
(fig. 1) To detach the Klik n' Flip Mop Head, press
the release button (fig. 2a) and slide off.
Mop
®
fig. 2a
fig. 2b fig. 3
fig. 5
fig. 4
3 To attach the Dirt Grip
floor with the pocket side up. Center the Klik n' Flip
Mop Head above the pad, then press the pad release
button on the back of the Steam Mop body. (fig. 2a)
Both sides of the Klik n' Flip Mop Head will drop
open. (fig. 2b) Slip the Klik n' Flip Mop Head's four
corner tabs into the four corner pockets of the pad.
(fig. 3 and fig. 4) Gently press one side of the Klik
n' Flip Mop Head to the floor until that side clicks into
place. (fig. 5) Repeat on the other side. (fig. 6)
4
Pull down on the water tank lid to open. (fig. 7)
5
Use the filling flask to pour water into the water tank.
(fig. 8) Water can be poured into the tank directly.
Do not overfill past the water line on the fill flask.
Press the water tank lid firmly to close it.
fig. 7
fig. 6
pad, spread the pad on the
™
fig. 8
www.sharkclean.eu 35