Télécharger Imprimer la page

Harvia SOLIDE OUTDOOR 2 Instructions De Montage page 46

Publicité

EN
Installing the sauna room door and
Duo glass wall
Install support board (CT) for Duo glass wall to side wall
and bracket (G) to terrace wall in the same line than
partition wall.
NOTE! At this point is good to place the heater inside the
sauna room.
Lift the glass wall module (02) into place. Glass wall
frames must not be fixed to the wall logs, to allow the
wood's natural movement.
Lift the door module (01) into place. Take care not to let
the door module tip over, until all side wall logs (E2) have
been installed. Place the logs from above to the bottom.
46
CT
02
O1
E2
DE
Installieren der Saunakabinentür und der
Duo Glaswand
Montieren Sie das Stützholz (CT) für die Duo Glaswand
an der Seitenwand und die Halterung (G) an der
terrassenseitigen Wand (an der Position der Trennwand).
ACHTUNG! Jetzt ist ein guter Zeitpunkt, um den
Saunaofen in der Saunakabine aufzustellen.
Heben Sie das Glaswandmodul (02) an die vorgesehene
Position. Damit die natürliche Bewegung des Holzes
nicht behindert wird, dürfen die Rahmen der Glaswand
nicht an den Wandbohlen befestigt werden.
Heben Sie das Türmodul (01) an die vorgesehene
Position. Achten Sie darauf, dass das Türmodul nicht
kippt, solange nicht sämtliche Bohlen der Seitenwand
(E2) montiert wurden. Montieren Sie die restlichen
Bohlen übereinander.
!
G

Publicité

loading