Kicker iKICK iK350 Manuel D'utilisation page 2

Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
The KICKER iKICK iK350 Digital Stereo System for iPhone and iPod is designed for "Livin' Loud" with your iPhone and
iPod in the home environment. The iK350 is fully featured with dual full-range 4" (`102mm) KICKER drivers and 1/2"
(13mm) Mylar tweeters driven by a powerful stereo amplifi er with digital signal processing. The 4.5" (114mm) square
passive radiator (subwoofer) on the back of the iK350 balances the sonic output, adding the punchy low-frequency
response that put KICKER subwoofers on the map. The rotary control and infrared remote allow simple, streamlined
control of your iK350 Stereo System. The iK350 can be used with any 4th generation or newer iPod. In addition, the
iK350 boasts a wide range of connectivity options including stereo RCA outputs, composite video output, and a 1/8"
stereo auxiliary input for incorporating additional audio devices with your iK350 Stereo System. Note: Third Generation
and older iPods work by connecting their headphone output to the auxiliary input on the rear of the iK350.
DOCKING YOUR iPod
1. Attach the included Adjustable Device Support to the docking bay.
2. Connect your iPod to the iK350's dock connector.
3. Plug the power cable into the DC input on the back of the iK350.
4. Plug the 2-prong electrical plug into a surge protected electrical outlet.
The iK350 will begin to authenticate your iPod. During this time, the
"DOCK" LED will fl ash until authentication is complete. If "DOCK" continues
to fl ash after 60 seconds, authentication has failed; Disconnect and
reconnect the iPod. If problems persist, test another iPod or iPhone device,
or contact KICKER support or Apple support.
5. Press the rotary control knob to exit Standby mode and activate the
iK350.
PERFORMANCE
The iK350 docking station has been optimized to match the sonic output of the iPod with the iPod's EQ in the "Off"
setting. The iPod's "Sound Check" should also be off; otherwise you may experience poor bass response and lower
volume levels in your music.
Model:
Speaker Design
Woofer Size, in (mm)
Tweeter Size, in (mm)
Tweeter Design
Passive Radiator Size, in (mm)
RMS Power, Watts @ 1% Total Harmonic Distortion
Effective Frequency Range, Hz
Power Supply, Volts (Ampere)
Height, in (mm)
Width, in (mm)
Depth, in (mm)
Weight, lb (kg)
2
DIGITALSTEREOSYSTEMFORiPhone
iK350
iK350STEREOSYSTEM
Owner'sManual
Figure 1
iK350
2 - Way
4 (102)
1/2 (13)
Mylar
4.5 X 4.5 (114 X 114)
2 X 10
65-20K
12 (3)
8 (203)
15 (381)
7 (178)
7.38 (3.3)
® ANDiPod ®