Operation; Battery Installation & Usage - TXED BIKE E-TIME CITY 8000MM Mode D'emploi Et Entretien

Warning: do not wash this electric bike direct with spraying water especially pressure
washers. Avoid water entering electric components as this may result in damage of the electric
components.

3. Operation

E-Times City 8000HM is a revolutionary transport means, applying aluminum frame, Li-ion battery, a super
high efficiency electric motor and controller with electric pedal assistance system, to support normal
pedaling. The above-mentioned equipment will ensure safe riding with excellent function and performance.
It is important for you to note the following guidelines to ensure getting the best possible experience from
your electric bicycle.
Checklist before riding
3.1.1 Please ensure tires are fully inflated as indicated on the tire wall, before riding.
Remember, performance of the bike is directly related to the weight of the rider and baggage/load,
together with the stored energy in the battery;
3.1.2 Charge overnight, prior to riding the next day;
3.1.3 Apply chain oil periodically and clean if dirty or gummed up, using degreaser, then wipe clean and oil
bicycle chain again.
4. Battery installation & usage
The electric bikes have the battery positioned within the rear carrier (the battery pack is directly connected
to the controller box in the front. (Fig. 2)
The slider of battery is fixed on carrier by bottom screws (Fig. 2.1).
Then the battery case is locked by the key (Fig. 4.1 & 4.2) see the operation details below.
(Fig.2) (Fig.2.1)
(Fig.3)