Publicité
Les langues disponibles
Les langues disponibles
Assembly
Solar Panel Wall or Deck Mounted
1. Secure bracket to solar panel with screw provided as shown in Fig 5.
2. Set bracket on surface and secure in place with larger screws provided as shown in Fig 6.
3. Adjust angle of solar panel to ensure it receives optimum sunlight.
Note: The Solar Panel is equipped with a 5 meter cord so both units can be installed up to 5 meters apart.
Lamp Installation
1. Using 'U' shaped mounting plate located to the rear of the lamp to mark where you want to install the
lamp (7) Fig 1.
2. Make sure this is clear of obstacles such as cables and electric lines.
3.
Secure lamp to the wall with screws provided.
4. Carefully route the power cord from the solar panel to the lamp and plug it into the battery housing input.
5. Adjust the motion sensor so that it faces the area where motion is most likely to be detected. You can
move it up and down by adjusting the screw on the neck of the motion detector.
Note: Lamp unit should be mounted 2 – 3 meters (6.5 – 9.8ft) from the ground to ensure motion
detection is optimised.
Operation
1. Located on the front of the light there is a switch with 3 positions. (8) Fig 4.
a.
'Auto' – When the switch is in the 'Auto' position the 60 LED Solar Security Light will turn on
automatically at night once motion is detected
b. 'On' – When the switch is in the 'On' position the light will remain on and can be used as a
regular light.
c.
'Off' - When the switch is in the 'Off' position the light will remain off and will not detect any
movement.
2. Allow 60 LED Solar Security Light to charge for at least 3 days with the switch in the 'Off' position.
Page 3 of 10
Publicité
