Orbegozo BV 9600 Manuel D'instructions page 13

BV 9600
DESCRIPTION AND ASSEMBLY OF THE PARTS
1. FILLER CAP. Insert cap into lid by aligning tabs and slots. Turn clockwise to lock. Turn counter-clockwise to
remove.
2. LID. Push lid onto jar until upper lid ledge is flush with upper lip of jar. Ensure that the lid is securely
positioned before operating the blender. Extra care must be taken especially when handling hot liquids.
3. JAR. 2.200 L jar made from durable BPA free triton with cup and milliliter markings. Place jar on centering
platform, ensuring that it is well seated.
4. BLADES. 6 stainless steel blades.
5. CENTERING PLATFORM. Pad which hold the jar in place on the blender base. It can be removed for
cleaning but must be repositioned before using the blender.
6. LOCKING NUT. Fastens blades securely to jar, it can be remove for cleaning with supplied tool.
7. DRIVE SOCKET. Hardened metal socket where jar connects with motor base to turn the blades.
8. BLENDER BASE. Where it is the motor and knobs of the blender.
9. ON/OFF SWITCH. The blender is off when the switch is in down position (OFF). It works in up position
(ON).
10. PULSE SWITCH. Keep pushing this switch to the blender works in max power momentarily, when you
leave pushing it the blender will stop or return to initial speed. This function can be use when on/off
switch is in ON or OFF position.
11. SPEED CONTROL. Turn the switch to the right to increase the speed of the blender and to the left to
reduce the speed.
12. POWER CORD AND PLUG.
13. RUBBER FEET. 4 rubber anti-slip feet.
14. TAMPER. It allows moving ingredients to be well blended safety. It only can be used throw the lid's hole so
it cannot touch the blades. If you need to move food at the jar's bottom, switch off the blender, unplug it,
remove the lid and introduce the tamper for moving the food.
15. OVERLOAD RESET BUTTON. To protect the motor from the overheat, the blender will stop automatically
before it overheats. If it happens return the ON/OFF switch to OFF position, remove the jar and wait for
the motor cool down. After 5-20 minutes the blender will reset automatically. If not, press this button
under the blender base.
13