Installation Procedure; Software Installation; Software Un-Installation - C2Ai Kt20 Notice D'utilisation

User Manual

Installation procedure

Replace paragraph II. A. in the user manual.
General overview
●
KT20 Kistock
KT20 interface
●
USB plug
How do you plug the KT20 ?
●
+
- Connect USB plug to the USB port of your
computer.
- Put KT20 on its stand (see picture
- Plug KT20 in one of the two connectors of
KT20 interface.
Warning
Plug only one KT20 at a time.
Minimum configuration
Replace paragraph I. A. in the user manual.
OS Configuration
Communication port
CD-ROM drive
Internet Explorer 6
RAM
Free disk space
A
KT20 Kistock
on its stand
KT20 Kistock
connectors
B
=
A )
Windows 2000 or XP
USB 2.0
128 MO
125 MO

Software installation

Replace paragraph I. B. in the user manual.
Warning
Before starting installation process, make
sure the USB cable is unplugged.
1. Insert « Kilog software » CD into CD-ROM
drive. The installation auto runs. If not, use your
browser to launch the « SetupKILOG » file from the
installation CD. After having selected setup
language, you must follow instructions.
2. Insert « KT20 software » CD into CD-ROM
drive. After having selected setup language, you
must follow instructions.

Software un-installation

Replace paragraph I. D. in the user manual.
Using « Start », « Parameters », « Configuration
panel », « Add/Delete program », select « KILOG »
and follow Windows recommendations to uninstall
the application. « FTDI USB serial converter
drivers » can be removed using the same
procedure.
KILOG software presentation
Replace paragraph II. B. 1. in the user manual.
KT-20 interface : Automatically detects KT-20
●
loggers and displays a configuration/downloading
interface.
KT-20 calibration : If a KT-20 is detected, this
●
menu allows you to adjust the measuring channel
using a single point method (offset only).