Publicité
Les langues disponibles
Les langues disponibles
Security
• The shower sump pump may not be used for other liquid than water/bilge water.
• Always install the pump with black lead (-) and brown/white lead (+).
• Always use the fuse required, see "Design features" below.
• The wire connections must be sealed with a marine sealant.
• All electrical wiring must be clamped with the connections well above the bilge wa-
ter level. Do not remove the insulation more than necessary. All wiring connections
should be sealed with a marine sealant oxidation.
• Do not run dry.
Design features
Model
flow rate
volt
(GPH)
(v)
SFBP1-G600-07
600GPH
12V
SFBP2-G600-07
600GPH
24V
SFBP1-G750-07
750GPH
12V
SFBP2-G750-07
750GPH
24V
Mounting instruction
Fasten the shower sump pump to the hull by screws in the four mounting holes.
Bedienungsanleitung_237720_Multi.indd 6-7
current
head
wire Lead
N.w/G.w
(A)
(M)
(M)
(kg)
2.5A
2.5
1 m
1.17/1.35
1,5A
2.5
1 m
1.17/1.36
3.OA
3.0
1 m
1.17/1.37
1,6A
3.0
1 m
1.17/1.38
operation
See illustration picture 1.
1. When the brown white wire connect to the positive (+) and the black wire connect
to the negative (-) the shower sump pump will start working.
2. When the bilge water rises and reaches the second detector cell at 45-50 mm (2")
the switch starts the pump.
3. When the water level has sunk to a level of 15-25mm, and the first detector cell is
above the water level, the pump is stopped. The shower sump pump system also
installed with schistose valve, when the pump stop working the valve will close to
prevent the black flow of the hose.
4. When the brown wire connect to the positive (+) and the black wire to the negative (-)
the shower sump pump have the same function as the normal blige pump without
automatic function.
Maintenance recommendations
To open the container for cleaning, unscrew the lid.
The motor and float switch assembly can be pulled out for removal of hair or debris.
If necessary, remove the filter and wash it.
waste handling / material recycling
At the products end of life, please dispose of the product according to applicable law.
Where applicable, please disassemble the product and recycle the parts material.
Picture 1
27.12.12 15:53
Publicité
