Reference Standards And Laws; Unpacking; Positioning; Connections - Virtus 70/40 FRE8+8 Installation-Emploi-Entretien

current safety standards and the instructions in this
manual.
Appliance maintenance and conversion to a different
type of gas must be carried out by qualified
technicians authorized by the manufacturer, in
compliance with current safety standards and the
instructions in this manual.
Do not obstruct any air vents or drains present on the
appliance.
Do not tamper with appliance components.
4.

REFERENCE STANDARDS AND LAWS

- Install the appliance in accordance with the safety
standards in force in the country.
5.

UNPACKING

- Check the state of the packing and in the event of
damage, ask the delivery person to inspect the goods.
- Remove the packing.
- Remove the protective film from the outer panels.
Use a suitable solvent to remove any residual
adhesive from the panels.
6.

POSITIONING

The overall dimensions of the appliance and the
position of connections are given on the installation
diagram at the end of this manual.
The appliance can be installed singly or in
combination with other appliances in the same
product range.
The appliance is not suitable for integrated
installation.
Position the appliance at least 10 cm from adjacent
walls.
If the appliance is to be be placed near walls, dividers,
kitchen furniture, decorative elements etc. this must
be made of non-combustible materials
Otherwise, they must be covered with suitable non-
combustible heat insulating materials.
Level the appliance by means of the height-adjustable
feet
APPLIANCE ASSEMBLY WITH BASE, BRIDGE AND
CANTILEVER SOLUTIONS
Follow the instructions provided with the type of
support utilized.
FIXING THE APPLIANCE TO THE FLOOR
If the appliance is installed alone, check if it needs to
be fixed to a top or to the floor. (TAB 5)
Secure the appliance to the floor one by one using
the adjustable feet, flanged or specific bracket
For single models refer to the technical data tables at
the bottom of this manual and to the Illustration
section.
JOINING APPLIANCES TOGETHER IN LINE
Remove the control panels. (A)
Remove the fixing screw nearest the panel from each
of the sides to be joined. (B)
Place the appliances side by side and adjust the tops
to the same height. (C)
Insert the (supplied) connector platein the seat
provided on the side of the top. Join the appliances
by screwing down the connector plate using the the
flat-headed M5 screws (supplied). (D)
Turn one of the two internal tabs of the appliances to
be joined by 180°. (E)
Join the appliances by screwing the M5x40 screw on
the opposite insert. (E)
FUMES EXHAUST SYSTEM
Create a fumes exhaust system based on the " Type "
of appliance. The " Type " is stated on the appliance
dataplate.
" A1 " TYPE APPLIANCE
Position the "A1" type appliance below an extractor
hood to ensure smoke and fumes generated by
cooking are removed.
" B21 " TYPE APPLIANCE
Position the "B21" type appliance below an extractor
hood.
" B11 " TYPE APPLIANCE
Fit the "B11" type appliance with a suitable fl ue,
available from the appliance manufacturer. Follow
the assembly instructions provided with the flue.
Connect the flue to a 150/155 mm diameter hose,
heat resistant to 300°C.
Vent to the outside or into an effi cient fl ue. The
hose length must not exceed 3 metres.
7.

CONNECTIONS

The position and dimensions of connections are given
in the installation diagram at the end of this manual.
CONNECTION TO THE GAS SUPPLY
- Check that the appliance is designed to operate with
the type of gas supply present on site. Check the
17