Hestan Cue KRCR24 Mode D'emploi page 38

TESTING AND INITIAL START-UP
INITIAL STARTUP
Once the appliance is plugged in, the display should show
EN
Turn the appliance ON by pressing the Power
show the message "Initial test" for approximately 2 minutes. After this phase the compressors
will start up and remain on until the default temperature (set at the factory) is reached. Allow
ample time for the refrigerator to reach this temperature before loading any items (6-12 hrs).
Ice Maker
If the appliance is provided with an ice maker:
1) Make sure that the water filter cartridge is properly installed
2) Purge air from the water lines by enacting the 'Manual Clean' function from the Menu-
>Functions->Water Filter options. You may need to complete this sequence several times
until you stop hearing air sputtering from the ice maker fill tube.
3) Once the procedure has completed, turn the Ice Maker on by touching the
KRB) or by using the menu:
Bottom Drawer
Models KRP, KRB, and KRW have a bottom drawer which defaults to freezer operation. The
drawer can also be set to other modes of operation. See the Use and Care manual for more
information.
Readiness
If at first the Start Up message does not appear but other information in the display does
appear (such as Fridge too warm, Freezer too warm, or audible signals are heard), the
refrigerator has still begun the normal cooling process.
If this is the case, deactivate any audible signals by pressing the Alarm button, close the door
and wait until the set temperature is reached.
It is necessary to let the unit reach the correct temperature prior to placing food or beverages
in it. (Allow 6-12 hours.)
For further information about the appliance operation, refer to the Use and Care Manual.
36
©2019 Hestan Commercial Corporation
Turn icemaker ON
OK
Turn icemaker OFF
OK
(CONT.)
button for three seconds. The display will
OK OK
OK
OK OK
OK
.
button (KRP,