Kohler K-2313 Guide D'installation page 5

Pinch wing nut closed to
insert into the lavatory hole.
4. Install the Lavatory to the Brackets
CAUTION: Risk of personal injury or product damage. Do not attempt to lift or install the lavatory
without assistance. The lavatory can break, chip, or cause personal injury if handled carelessly.
Pinch the toggle wing nuts closed on the toggle bolt assemblies and insert through the back holes of
the lavatory bottom.
Align the inserted bolts on the lavatory with the holes at the rear of the brackets and slowly lower
the lavatory onto the brackets.
Pinch the toggle wing nuts closed on the remaining two toggle bolt assemblies and insert through
the slots on the tie bar and into the lavatory, as shown.
CAUTION: Risk of product damage. Do not overtighten the bolts. Overtightening will damage the
lavatory.
Tighten all bolts.
Kohler Co.
Toggle Wing Nut
Toggle Bolt Assembly
As Viewed From Below
5
Insert toggle bolt
into front slot on each
bracket.
Tie Bar
1012579-2-D