Kohler K-2313 Guide D'installation page 2

Tools and Materials
Pencil
Level
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before
you start installation. If you encounter any installation or performance problems, please don't hesitate to
contact us. Our phone numbers and website are listed on the back cover. Thanks again for choosing Kohler
Company.
Before You Begin
CAUTION: Risk of personal injury or product damage. Do not attempt to lift or install the lavatory
without assistance. The lavatory can break, chip or cause personal injury if handled carelessly.
CAUTION: Risk of product damage. Do not use plumbers putty with this product. Plumbers putty
can cause permanent discoloration of product surfaces. Sealant is the required for the installation.
Observe all local plumbing and building codes.
Refer to the Homeowners Guide to determine all necessary components for your installation.
Prior to installation, unpack the new lavatory and inspect it for damage. Return the lavatory to its
protective carton until you are ready to install it.
Inspect the existing drain and supply tubing. Replace if necessary.
If installing multiple components (vanity, cabinet, countertop, lavatory), read all component
installation instructions before beginning the lavatory installation. Some components should be
installed before others. Refer to the Homeowners Guide for sample configurations.
To ensure the lavatory functions properly, all components (vanity, cabinet, countertop, lavatory)
must be level.
The K-3081 model wall-mount vanity is designed for placement under the lavatory.
If brackets are installed for the natural lavastone countertop, no additional brackets are required for
this installation.
This lavatory is designed for use with Kohler mirrored cabinets with integrated laminar flow faucet.
A wall-mount faucet (minimum spout length 12" (30.5 cm)) may also be used with this lavatory.
Before installing the finished wall, make sure the proper brackets are installed for each of your
component choices in this product line (consult the Homeowners Guide for proper configuration).
Plumbing and electrical (if applicable) rough-ins should also be completed before installing the
finished wall.
1012579-2-D
Measuring Tape
Silicone Sealant
Phillips
Screwdriver
Plus:
• Screws
• Washers
2
Drill
Safety Glasses
Kohler Co.