Setting Time Zone - ELV Electronik WS 250 Edition Notice D'emploi

+
-
NEXT
+
-
NEXT
+
-
EXIT
configuration
or
NEXT
+
-
NEXT
46
Set the latitude using the keys „+" and „-".
latitude
Example: 52.5°, input: 525
Press the „NEXT" key. After that, you can enter the longitude.
The display shows this as „LO" („Longitude").
Set the longitude using the keys „+" and „-".
longitude
Example: 13.4°, input: 0134
Press the key „NEXT" and now set the time zone. The display
shows „ti".
Setting the time zone
The time zone is required for the calculation of the sunrise and
sunset times.
Enter the difference to GMT (Greenwich Mean Time).
The following values apply for Germany:
• Daylight saving + 2
• Winter time + 1
time Enter the current value for your time zone using the keys „+"
zone and „-".
All settings have been made at this time for correct operation
of the weather station. The extended settings are not required
for normal operation.
terminating Now press „EXIT" to leave the configuration mode and return
to normal mode. Now the base station is back in normal mode.
extended Press the key „NEXT" to make extended settings and go to
settings the balancing of the rain sensor.
Entering the alignment value
The rain gauge has been set to a high degree of accuracy ex
works so that you normally do not need to align it.
Simply press „NEXT" to take over the factory settings.
Otherwise the alignment value will have to be determined
first of all in normal mode (see chapter 13 d) on page 56).
Enter the previously determined alignment value using the keys
alignment
„+" and „-".
value
Press „NEXT" to set the unit for measuring rain.