Leatt Fusion 3.0 Mode D'emploi page 5

6. Brace adjustment
The spacers should be changed if the brace does not fit
5d.
Same size spacers should be used on both sides
Please Note!
If the Fusion does not correctly fit and cover the areas specified , an alternative
size may be required. Please contact Leatt ® Corporation or go to www.leatt.com
if you require further advice on sizing, adjustment or fitting.
Cleaning
DO NOT MACHINE WASH THE FUSION
DO NOT USE ANY BLEACH ON THE FUSION
LINE DRY, DRIP DRY OR DRY FLAT IN THE SHADE
DO NOT DRY CLEAN THE FUSION
DO NOT IRON THE FUSION
DO NOT USE ANY SOLVENTS ON THE FUSION
Wipe only with a soft cloth damped in gentle soap or mild detergent in cold
water, rinse by wiping with a soft cloth damped in cold water and dry with a soft
cloth. Common substances applied to this product (solvent, cleaners, hair tonics,
etc.) can cause damage that may be invisible to the user and compromise the
effectiveness/safety of your Leatt ® protector.
7 Copyright © 2014, Leatt ® Corporation
Always refer to the material content label on the Fusion. None of the materials
used in the construction of the product are known to contain anything that might
cause an allergic reaction or be dangerous to health.
Storage and transportation
Place on a clean, dry surface and store in a dry, well-ventilated environment
away from direct sunlight and extremes of temperature. Do not place heavy
objects on top of your Fusion.
The protection provided by your Fusion should not be affected by non-extreme
ambient temperature and weather conditions.
Maintenance and Obsolescence
For maximum performance, your Fusion Vest 3.0 must be inspected prior to each
use. Stop using the protector if any components show signs of damage or are
worn, cracked, and/or deformed, or if the inside padding has deteriorated. Leatt ®
Corporation recommends that your Fusion should be replaced every three (3)
years under normal use conditions.
Should you experience a collision or if your Fusion or any component shows any
signs of damage, cracking, deformity and/or the inside padding is deteriorating,
return the product to the seller for inspection or destroy and replace it. Please
dispose of it in an environmentally-friendly manner.
Do not drill holes, paint, cut, heat, bend, apply decals or stickers, or make any
other modifications to the Fusion. Doing so may compromise the effectiveness
and safety of your Leatt ® product.
Copyright © 2014, Leatt ® Corporation 8