SPREADER POLE ATTACHMENT / SKIN ASSEMBLY
#27821
(26540/28878)
ASSEMBLY
10
Assemble (26540/28878) to #27821 and #26536
using (2) 2 -1/2 IN Philips drive bolts, (2) washers, and
(2) nuts.
(26539/26542)
ASSEMBLY
#27729
#26536
(26540/28878/26542)
ASSEMBLY
12
(A) Attach #27729 to (26539/26542) and (26540/28878/26542)
assemblies as shown in Figure 13. Be sure to fully extend (26539/26542)
and (26540/28878/26542) assemblies until locked prior to attaching
#27729.
(B) Adjust the length of #27729 to position (26539/26542) assembly, using
the edge of #26536 as a guide. This provides initial positioning, though
once the skin is attached to each pole assembly this location
will vary and need to be adjusted.
TIP: Once the skin has been fully assembled to the frame and sled, make a
locating line using a permanent marker that can easily be seen for faster
set-up when on the ice.
8
#26536
SEE
DETAIL
11
#27730
13
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
|
26500
Grizzly™ Flip-Style Sled Shelter
(A) Attach #27730 to #25020 and (26539/26542)
as shown in Figure 12. Be sure to fully extend
(26539/26542) assembly until locked prior to
attaching #27730.
(B) Adjust height of #27730 until the (26539/26542)
assembly is tangent to the edge of #25020 as shown
in Figure 12.
#26529
(A) With #27729 and #27730 in place as shown in
Figure 14, begin working the #26529 skin assembly
over the aluminum frame work.
(B) There are hook-and-loop connections sewn on
the inside of the skin to attach/locate each aluminum
frame assembly. Secure each connection as snug as
possible. This will determine how tight the skin will
be once attached to the #25020 sled.
Operator's Manual
(26539/26542)
ASSEMBLY
#27730
#25020