The First Wash Cycle; Technical Data - Hotpoint Ariston FDD 10761 Mode D'emploi

Connecting the drain hose
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose
and must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electri-
city socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maxi-
mum power load of the appliance as indicated
in the Technical data table (see opposite);
• the power supply voltage falls within the va-
lues indicated in the Technical data table (see
opposite);
• the socket is compatible with the plug of the
washer-dryer. If this is not the case, replace
the socket or the plug.
! The washer-dryer must not be installed ou-
tdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washer-dryer has been installed,
the electricity socket must remain within easy
reach.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be repla-
ced by authorised technicians.
Connect the drain
hose, without bending
it, to a drain duct or
a wall drain situated
between 65 and 100
cm from the floor;
alternatively, placed
it over the edge of a
basin, sink or tub, fa-
stening the duct sup-
plied to the tap (see
figure). The free end
of the hose should
not be underwater.
Warning! The company shall not be held
responsible in the event that these standards
are not observed.

The first wash cycle

Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using
wash cycle number auto clean (see "Cleaning
the washer-dryer").

Technical data

Model FDD 10761
width 59.5 cm
Dimensions height 85 cm
depth 60,5 cm
from 1 to 10 kg for the wash
programme
Capacity
from 1 to 7 kg for the drying
programme
Electrical please refer to the technical
data plate fixed to the machine
connections
maximum pressure 1 MPa
(10 bar)
Water con-
minimum pressure 0.05 MPa
nections
(0.5 bar)
drum capacity 71 litres
up to 1600 rotations per
Spin speed
minute
Wash: programme 2; tempe-
rature 60°C (1st press of the
button); using a load of 10 kg.
Energy ra- Drying: the smaller load
ted (3kg) must be dried by se-
programmes lecting the "EXTRA" dryness
level. The load must consist
according to
regulation of 3 sheets, 2 pillowcases
EN 50229 and 1 hand towel;
the remainder of the load
must be dried by selecting
the "EXTRA" dryness level.
This appliance conforms to
the following EC Directives:
- 2004/108/EC (Electromagne-
tic Compatibility)
- 2006/95/EC (Low Voltage)
- 2012/19/EU
GB
3