Programming Example - Topmodel XPower XREG80HV Manuel D'utilisation

PROGRAMMING EXAMPLE

Setting startup mode to "super-soft", i.e. value #3 in program item #5
1.Entering Programming Mode
Switch on transmitter, move throttle stick to top, connect battery pack to ESC, wait for 2 seconds, "beep-beep" tone should be
emitted. Then wait another 5 seconds, special tone like "56721"should be emitted, means programming mode is entered.
2.Selecting Items
Now you'll hear 8 tones in a loop. When a long "beep------" tone is emitted, move throttle stick to bottom, select the "Startup Mode"
item
3.Set Item Value
"Beep-", wait for 3 seconds; "Beep-beep-", wait for another 3 seconds; then you'll hear "beep-beep-beep", move throttle stick to top,
• •
then a special tone "1515 " is emitted, now you have set the "Startup Mode" in "Super-soft Startup"
4.Exit Programming
• •
After the special tone "1515 ",move throttle stick to bottom within 2 seconds.
TROUBLE SHOOTING
TROUBLE
After power on, motor can't work, no
sound is emitted
After power on, motor can't work, such a
alert tone is emitted:
"beep-beep-, beep-beep-,beep-beep-"
( every "beep-beep-" has a time interval
about 1 second. )
After power on, motor can't work, such a
alert tone is emitted:
"beep-, beep-,beep- "
( every "beep-" has a time interval about
2 seconds. )
After power on, motor can't work, such a
alert tone is emitted:
"beep-, beep-,beep- "( every "beep-" has
a time interval about 0.25 second. )
After power on, motor can't work, a spe-
• •
cial tone "56721" is emitted after 2 beep
tones (beep-beep-)
The motor runs in opposite direction
The motor stop running while in working state
POSSIBLE REASON
The connection between battery pack
and ESC is not OK
Input voltage abnormal, too high or
too low
Throttle signal is abnormal
Throttle stick not in bottom( lowest)
position
The direction of throttle channel is
reversed, so the ESC has entered the
programming mode
The connection between ESC and the
motor need to be changed.
Throttle signal is lost
ESC has entered Low Voltage
Protection mode
Some Connections are not reliable
Distribué par/Distributed by:
TOPMODEL S.A.S.
Le jardin d'entreprises de SOLOGNE - F-41300 SELLES SAINT DENIS - www.topmodel.fr
©TOPMODEL 2007 v. 1-3
• •
8
ACTION
Check the power connection.
Replace the connector.
Check the voltage of battery pack
Check the receiver and transmitter
Check the cable of throttle channel
Move the throttle stick to bottom
Set the direction of throttle channel
correctly
Swap any two wire connections
between ESC and motor
Check the receiver and transmitter
Check the cable of throttle channel
Land RC model as soon as possible,
Replace the battery pack
Check all the connections: battery
pack connection, throttle signal cable,
motor connections, etc.