Turning Off; Maintenance - Dantherm ACT-7 Guide De Démarrage Rapide

Turning off
If you wish to turn th e device off and disconnect th e power
supply, switch th e device to standby for a minimum of
30 minutes to allow for th e condensate pump to drain
th e system. The hoses and th e mains power can th en be
disconnected.
Failure to follow th e above procedure may result in
excess water being retained in th e system which may
spill when th e ACT-7 is moved.
Routine maintenance
The air fi lter must be kept clean. Never allow th e fi lter to
become obstructed with dust or dirt. If allowed to do so, poor
performance and component damage may occur. The fi lter
is fi tted to th e rear of th e panel shown below and is held
on with magnets. Remove th e panel by pushing th e panel
up using recesses at th e bottom. Remove th e fi lter, vacuum
excess dirt, and wash it with soapy water. Leave th e fi lter to
dry before refi tting it and operating th e ACT-7.
Push cover up
Recesses
13
ACT-7 QUICK START GUIDE