Introduction - Viatom Checkme O2 Manuel De L'utilisateur

1. Introduction

1.1 Intended Use
This product is intended to be used for measuring,
displaying and storing of pulse oxygen saturation
(SpO ) ， pulse rate and motion in home or healthcare
2
facilities environment. App can show real-time SpO
pulse rate; get record, display results and report.
Note:
The data and results provided by this device are for pre-check
screening purpose only and cannot be directly used for diagnostic
or treatment.
The data provided by the APP and PC software (optional) is not
intended for diagnosis or treatment purpose, always consult your
doctor for any health condition.
Warnings and Cautionary Advices
DO NOT squeeze the sensor or apply excessive force on

the sensor & cable.
Do not use this device during MRI examination.

Never submerge the device in water or other liquids. Do

not clean the device with acetone or other volatile solutions.
Do not place this device in pressure vessels or gas

sterilization device.
Consult your doctor immediately if you experience

symptoms that could indicate acute disease.
Do not self-diagnose or self-medicate on the basis of this

device without consulting your doctor. In particular, do not
start taking any new medication or change the type and/or
dosage of any existing medication without prior approval.
Use only cables, sensors and other accessories specified

2
,
2