Publicité
Les langues disponibles
Les langues disponibles
5.0 Maintenance and Service
Maintenance and Cleaning
► Before any work on the machine itself, pull the
mains plug.
► For safe and proper working, always keep the ma-
chine and ventilation slots clean.
After fi nishing work, dismount the clamping fi xtures and
clean all clamping parts as well as the protective cover.
When the carbon brushes are worn out, the machine
switches itself off .
The machine must then be sent to an after-sales ser-
vice agent. Addresses are listed in the Section "After-
sales service and customer assistance".
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
WOLFF power tools.
In all correspondence and spare parts orders, please
always include the 10-digit article number specifi ed on
the type plate of the machine.
5.1 Spare parts
Spare parts are available on the Internet:
http://webcatalog.wolff -tools.com can be found.
6.0 Troubleshooting
Fault
Possible cause
The machine
Battery is empty
does not start
interrupted
Higher exer-
Cutting blade
tion of force
dull
required while
working
Machine auto-
Overload protection
matically
has been activa-
switches off
ted
Remedy
Charge battery on
station
Replace
cutting blade or
resharpen
Machine after
a cooling time
turn back on
7.0 Disposal information
The machine, accessories and packaging should be sor-
ted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste!
According the European Guideline 2002/96/
EC for Waste Electrical and Electronic
Equipment and its implementation into na-
tional right, power tools that are no longer
usable must be collected separately and
disposed of in an environmentally correct manner.
Subject to change without notice.
EN
22
Publicité
