Sleep Timer; Reminder Timer; Information - Salora CR620RDS Manuel D'utilisation

SLEEP TIMER

The device can be set to turn off after a preset time has elapsed. The sleep setting can be adjusted
between 10 and 90 minutes in 10-minute intervals.
This function cannot be activated when the device is switch on.
Setting the sleep timer
1. Switch on the device from standby mode.
2. Repeatedly press the >SLEEP/NAP< button to select the sleep time in 10-minute intervals.
–The symbol > < is shown on the display.
3. You can press the >SLEEP/NAP< button to view the remaining time until switch-off.
The device will switch off automatically after the preset sleep time has elapsed.
Cancelling the sleep timer
1. To cancel the sleep timer and switch off the device before the chosen sleep time has elapsed, press
the >ON/OFF< button.
or
To cancel the sleep timer, but keep listening to the radio, press the >SLEEP/NAP< button repeatedly
until the display shows "SLEEP 00" and the symbol >

REMINDER TIMER

The device can be set to remind you after a certain time between 10 and 120 minutes in 10-minute
increments with a signal tone.
This function cannot be activated when the device is in standby mode.
Setting the reminder timer
1. Switch the device to standby mode.
2. Repeatedly press the >SLEEP/NAP< button to select the reminder time in 10-minute increments.
3. You can view the remaining reminder time by pressing the >SLEEP/NAP< button briefly.
Cancelling the reminder timer
1. To cancel the reminder timer by pressing the >ON/OFF< button.
Notes:
The signal tone can be interrupted by pressing the >SNOOZE< button. The signal tone goes off again at
5-minute intervals (overall alarm duration is 90 minutes)
<disappears.
10

INFORMATION

Technical data
Mains operation
Power Supply
Back-up batteries
Frequency Coverage FM
Circuit Features Loudspeaker
Output power
Headphone socket
Aerial System FM
General
Dimension of unit
Technical and design modifications reserved.
Never open the device casing. The manufacturer will not accept any liability for damage resulting from
improper handling.
Environmental note
This product has been made from high-quality parts and materials which can be reused
and recycled.
Therefore, do not throw the product away with normal household waste at the end of its life.
Take it to a collection point for recycling electrical and electronic device. This is indicated by
this symbol on the product, in the operating manual and on the packaging.
Please find out about collection points operated by your local authority.
Help protect the environmental by recycling used products.
AC 230V, 50Hz~ only
2 x 1.5V (LR03 / UM-4 / AAA size)
87.5 – 108MHz
Size 1 x Ø76 mm
Impedance 8 ohms
750mW into 8 ohms
Ø3.5 mm
Wire antenna
178L x 51H x 144D (mm)
11