Vollrath JB2H Manuel De L'opérateur page 2

FEATURES
A
B
C
D
E
Front View
A Adjustable Heat Shields (front and back)
B Crumb Tray
C Conveyor Speed Knob
D On/Off Knob
Full Power - maximum heat
Off
Standby - reduces electrical consumption by 75%.
BEFORE FIRST USE
1. Clean the oven. See "Daily Cleaning" on page 3.
2. Insert the crumb tray. Features
OPERATION
CAUTION
Burn Hazard
Do not touch the equipment while it is heating or operating.
Hot surfaces can burn skin.
NOTICE: The crumb tray must be installed in the oven during
operation. Failure to install the crumb tray will cause the
oven to overheat.
Adjust the Heat Shield
Excess space above the product will create heat loss and may reduce
performance.
1. When the equipment is cool to the touch, use a screwdriver to
loosen the screw on the heat shield.
2. Grasp the shield and pull it up or down to adjust the opening so the
tallest products can pass through. Re-tighten the screw.
Preheat
1. Plug the oven into a grounded electrical outlet that matches the
rating on the name plate found on the side of the oven.
NOTICE: Using a voltage other than the nameplate rated voltage
will cause damage to the unit. Incorrect voltage,
modification to the power cord or electrical components
can damage unit and will void the warranty.
2. Rotate the power knob to the full power position (I).
3. Set the conveyor speed control knob to 7.
4. Rotate the top and bottom heat control knobs to high.
2
F
40 Inch Conveyor Sandwich Ovens Operator's Manual – Models JB2H and JB3H
H
G
Side View
E Top Heat Control Knob
F Bottom Heat Control Knob
G Reset Button (Reference only. Access from the back. See page 3.)
H Conveyor (load side)
I Unload Tray
5. Wait 5 minutes for the oven to preheat.
Test
1. Test the settings by placing a sandwich into the oven. Sandwiches
can be placed directly onto the conveyor or on a pizza screen.
NOTICE: Pans, especially shiny pans, and aluminum foil will
reflect heat away from the sandwich and reduce
browning.
2. Monitor the toasting process and adjust the temperatures and
conveyor speed to prevent the sandwich from burning.
3. Evaluate the results.
Toast Sandwiches
1. Adjust the top and bottom heat control and conveyor settings as
needed to achieve desired results.
2. Allow time for the oven to adjust to new heat settings before placing
sandwiches onto the conveyor.
3. Allow space between the sandwiches on the conveyor and time in
between toasting for the oven to recover.
If an Item Becomes Stuck
1. Rotate the power knob to the OFF position (O) and unplug the
equipment.
2. Let the equipment cool completely. Use tongs to remove the item.
Take care to not bump the heating elements above and below the
conveyor.
A
I