Installation Precautions; Panel Facilities; Front Panel - Pioneer S-W1EX Mode D'emploi

Installation Precautions

• Install the unit in a well-ventilated location where it
will not be exposed to high temperatures and high
humidity.
• Do not place the unit near stoves or other heating
equipment or at locations exposed to direct sunlight,
as these can have an adverse effect on the cabinet
and internal components. Also, do not install the unit
where there is too much dust or high humidity, as
these can cause malfunctioning or breakdowns.
(Avoid cooking tables and other locations where the
unit would be exposed to heat, steam and soot.)
• Do not place heavy objects such as a television or TV
monitor on top of the unit.
• Keep the unit away from devices such as cassette
decks which are sensitive to magnetic fields.
This speaker system is magnetically shielded.
However, depending on the installation location,
color distortion may occur if the speaker system is
installed extremely close to the screen of a television
set.
If this happens, turn off the power switch of the
television set, and turn it on after 15 to 30 minutes.
If the problem persists, place the speaker system
away from the television set.
• Please install this unit away from the antenna cable
of the tuner, as noise can be caused with installation
close to the antenna cable. In such a case, use this
unit at a position away from the antenna and the
antenna cable, or when playback of extra bass is not
required, switch off the power for this unit.
MAINTENANCE OF EXTERNAL SURFACES
• Use a polishing cloth or dry cloth to wipe off dust
and dirt.
• When the surfaces are very dirty, wipe with a soft
cloth dipped in some neutral cleanser diluted five
or six times with water, and wrung out well, and
then wipe again with a dry cloth. Do not use
furniture wax or cleaners.
• Never use thinners, benzine, insecticide sprays
and other chemicals on or near this unit, since
these will corrode the surfaces.
All manuals and user guides at all-guides.com

PANEL FACILITIES

FRONT PANEL

1 1 1 1 Power switch (POWER)
When pressed, power is turned ON; when pressed again,
power is turned OFF.
2 2 2 2 Power Indicator (ON)
Illuminates when the power is on.
3 3 3 3 Bass mode switch (BASS MODE)
4 4 4 4 Crossover knob (CROSSOVER) & Bypass switch
When using the subwoofer, set the upper frequency limit
for the subwoofer (50–150Hz) so that it complemets the
output from your other speakers. When using the bass
managment features of an AV receiver, set to BYPASS in
order to use the low-pass filter of the AV receiver for high
quality sound.
• Setting Criteria
50Hz .......when the diameter of the left/right speakers
100Hz .....when the diameter of the left/right speakers
150Hz .....when the diameter of the left/right speakers
* When set to BYPASS, the audio signal is
1 2
The condition of closed door
1 2 3 4 5
Open the door.
—
MUSIC: The characteristic frequencies become flat.
Recommended for music sources.
_ CINEMA: Low frequencies are emphasized.
Recommended for sources that require strong bass.
(BYPASS)
is 20-cm or more.
is 10 – 25-cm.
is 12-cm or less.
routed directly to the woofer unit,
bypassing the amplifier's filter.
CROSSOVER
7
BYPASS
En