tiko Energy Solutions Sense-3 Mode D'emploi page 4

Temperature Sensor User's Manual
Device
IMAGE 1, IMAGE 2 and IMAGE 4 show the device from various sides. On the display
side, the unique serial/MAC address is displayed as text and QR code. If the device is
opened, on the inside labels is indicated:
• The manufacturer
•
The device model number (REF) and the current rating
•
The unique serial/MAC address as text and as Aztec 2D code (SN/MAC)
Installing the Sense-3
Step 1 Open the battery compartment by holding the bottom half (the one hav-
ing the LCD display) and by unscrewing the top part, rotation counter-
clockwise (IMAGE 6).
Step 2 Insert two AAA batteries the indicated way (IMAGE 7).
Step 3 Close the battery compartment by holding the bottom half and screw-
ing the top part, rotation clockwise (IMAGE 6).
Step 4 The LCD display shall show current temperature and humidity.
Step 5 The device is designed to be laid down on the user interface. This way,
the device can be placed at a height of approx. 1 - 1.5 meters, e.g., on a
bookshelf, without attracting attention.
Depending on the kit, a wall mount is included. Install this if, for exam-
ple, there is no shelf in a corridor to place the device on.
In this case, remove the protective film of the Velcro tape or Nano Tape
and press the wall holder onto the desired location.
Note: The adhesive on the Velcro tape needs 24 hours to reach its full
load-bearing capacity. The Nano Tape does not need curing time, but
the adhesive strength depends on the contact pressure.
Step 6 To finalize the installation, all tiko devices must be configured using the
installation app.
tiko Energy Solutions AG
English
Installation
IM-0007-0005 Rev. 10
4 / 32