AVM FRITZ!DECT 200 Mode D'emploi page 6

Registering with a FRITZ!Box
1. Insert FRITZ!DECT 200 into an outlet near your FRITZ!Box.
The DECT LED flashes regularly.
2. Within 2 minutes, press the DECT button on your FRITZ!Box, until the Info or DECT LED
starts flashing.
FRITZ!DECT 200 is registered with the FRITZ!Box. The wireless connection has been
established when the DECT LED on the FRITZ!DECT 200 lights up.
If the DECT LED continues to flash, registration was not successful. Remove
FRITZ!DECT 200 from the power outlet and repeat the registration process.
3. Now insert FRITZ!DECT 200 into the socket where you would like to use the device.
FRITZ!DECT automatically reregisters with the FRITZ!Box. When the connection has been
established, the DECT LED lights up.
If the DECT LED keeps flashing, try to register from a different outlet closer to the
FRITZ!Box. The outlet must be located within the range of the DECT radio network of
the FRITZ!Box.
6