Battery - GOVECS ELMOTO LOOP Notice D'utilisation

Removing the battery
You can remove the battery for storage or off-board charging�
• Turn the scooter off�
• Open the glove box�
• Pull the wire to open the seat�
• Unplug the battery connector�
• Remove the safety strap holding the battery�
• Lift the battery up by the handle�
Power button
• The Power button can be used to check the state of charge of
the battery�
• In case of a battery error, holding the Power button for
5 seconds resets the battery�
LEDs
• The 4 LEDs on the battery display the state of charge (SOC)� It is
displayed either continuously during charging, or for 20 seconds
after pressing the Power button�
• The table on the right show how the LEDs translate to SOC�
• When the battery is idle, a single blinking LED indicates an
error� Clear the error by resetting the battery with the Power
button� If that doesn't solve the issue, contact an authorised
Service Centre�

BATTERY

Action LED1
(red)
Button pressed
Button pressed
Button pressed
Button pressed
Button pressed
Charging
Charging
Charging
Charging
Charging
LED2 LED3 LED4 Description
(green) (green) (green)
0% <= SOC <= 10%
10% < SOC <= 25%
25% < SOC <= 50%
50% < SOC <= 75%
75% < SOC <= 100%
0% <= SOC <= 25%
25% < SOC <= 50%
50% < SOC <= 75%
75% < SOC <= 100%
SOC = 100%
EN
21