Publicité
Les langues disponibles
Les langues disponibles
Step 31
IMPORTANT : THIS UNIT MUST BE SECURE TO THE WALL TO HELP PREVENT TIPOVERl
FOLLOW THESE INSTRUCTIONS TO INSTALL THE ANTI-TIPPING SAFETY BRACKET
PROVIDED WITH THIS PRODUCTl
WARNING
Serious or fatal crushing injuries
can occur from furniture tip over
To prevent tip over
* Instal l l tip over restraint provided
* place heaviest items in the lowest
drawers
* Unless specifically designed to
accomodate, do not set TVs or other
heavy objects on the top of this
product
* Never allow children to climb or
hang on drawers, door, or shelves
* Never open more than one drawer
at a time
Use of tip over restraints may only
Reduce, but not eliminate the risk
Of tip over
OPTION 1: Attachment into a wall stud(preferred method)
Using a stud finder, locate a stud in the wall. Place your unit against the wall with the safety bracket
al i gned in this location.
To mal e driving the screw easier, you can drill a 1/8" diameter pilot hole (3mm) through the safety
bracket into the stud
Drive the sl rew through the safety bracket into the wall stud. Tighten the sl rew that was not fully
tightened in step 1.
OPTION 2: A
Locate your unit where desired against a wall and marl the wall through the safety bracket, then
move your unit asidel
Drill a 3/16" diameter hole (5mm) into the wal l board. Ta p the wall anchor into the hole until i l i it is flush.
Move your unitintol o caton and fasten the wal l bracketto the wal l anchor with the screw.
Tighten the screw that was not fully tightened in step 1.
littleseedskids.com
For Masonry, Concrete, or other
wall materials:
Consult your local hardware store
for appropriate anchors to securely
attach the safety bracket.
39
TM
hole
stud
wallboard
Publicité
