Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
EN Getting started
Note: this item only works with Calex Smart lamps and plugs.
Before you get started, make sure that the lamp or plug that you want to connect with the remote
control has already been added in the Calex Smart app.
Switch the device off and on ONE time to get the device into learning mode for the duration of 20
seconds.
Wait for 5 seconds. The lamp will connect to the local WiFi network. Press and hold the ON button on
the remote control (5-7 seconds) until the remote flashes 3 times. (The lamp or plug indicator flashes
once) Pairing succeded.
Lamps can be adjusted step by step in brightness in steps of 20%.
You can connect a lamp or plug to a maximum of five remote controls.
To disconnect, press the power OFF button for five seconds. All connected lamps, plugs and remote
controls are now disconnected.
You can connect several lamps and plugs at the same time by turning them on and inside 20 seconds to
complete the link as described above.
Declaration of Conformity
We, Electro Cirkel Retail BV, as importer declare that this "radio equipment" is produced in China. The products passed all tests according
to all relevant CE standards and regulations. The complete list of harmonized standards regarding directive 2014/53/EU can be found at:
https://ec.europa.eu/growth/single-market/european-standards/harmonised-standards/red_en
The complete Declaration of Conformity can be found at www.calex.nl For other compliant-related information please contact:
Website: www.Calex.nl, email: info@calex.nl,
Phone: 0102981980, Postal: Lyonstraat 29, 3047 AJ, Rotterdam, the Netherlands
Safety:
- The adaptor (if applicable) must be installed nearby the device, not connected to another adaptor and easy accessible;
- This product should only be opened by an authorized technician when service is required;
- Only use this device for intended purpose;
- Do not use this device if damaged or defective. In this case, replacement is required;
- This device is designed for in-doors use only. Do not use this device outdoors.
Disposal This product is designated for separate collection at an appropriate collection point. Do not dispose of the product with household waste.
Warranty: Any changes and/or modifications to the product will void the warranty. We cannot accept any liability for damage caused by incorrect use
of the product. Disclaimer: Designs and specifications might be subjected to change without notice. All logos, brands and used product references
are trademarks or registered trademarks of their respective holders and hereby recognized as such.
2
429204_Manual.indd 2
22-8-2019 09:20:50

Publicité

Table des Matières
loading

Table des Matières