LENCO BTL-450 White Mode D'emploi page 10

REMARK: When both USB and SD card are inserted, pressing the play button for a long time can
swap between USB and SD card.
9.6 Playing the FM radio
1. Press the "STANDBY" button to turn the unit on.
2. Ensure that the FM Antenna has been fully extended and press "SOURCE" on the top panel or
the "SOURCE" button on the remote control to adjust to the "FM" mode.
3. Press "Skip forward" or "Skip backward" and hold; the unit will scan the radio station, and stop
once it has found one.
4. For fine tuning 0.1MHz, press the "Skip Forward or Skip Backward" button once.
9.7 Programming & Playing of FM radio presets
1. Follow the steps for Playing the FM Radio.
2. Press the "Scan" button for a long time on the remote to search and preset stations in memory
(i.e. "P01" – this will blink on the display - and then the preset station frequency number will be
shown on the display).
3. Note: 30 FM stations can be preset.
4. To play the preset Radio Stations, press the "CH-" or "CH+" buttons to cycle through the preset
FM radio stations.
9.8 Manual FM station save
1. When under FM mode, press the Skip backward /Skip forward button to choose the
station.
2. Press the Scan/Memory button shortly; "P 00" will blink on the display which means
you enter into the manual saving state, and then Press the "CH-" or "CH+" buttons to cycle
through the preset FM radio stations.
3. Press Scan/Memory button to finish manual saving.
10. Cleaning the Appliance
Disconnect the appliance from the power source when cleaning.
If the unit becomes dusty, wipe it with a soft and dry duster. Use a soft cloth to clean this appliance.
Do not use any wax, polish sprays, or abrasive cleaners on the unit.
The normal function of the product may be disturbed by strong Electro-Magnetic Interference. If so,
simply reset the product to resume normal operation by following the instruction manual. In case
the functions could not resume, please use the product in another location.
Care and maintenance specifications
1. Always disconnect the equipment from the power supply
before cleaning.
2. Clean the equipment with a soft, damp, lint free cloth.
3. Do not use abrasives or harsh cleaners.
10