Connections - OBSIDIAN CONTROL SYSTEMS NETRON EN12 Manuel D'installation

Masquer les pouces Voir aussi pour NETRON EN12:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

C O N N E C T I O N S
A C C O N N E C T I O N S
The Obsidian Control Systems Netron EN12/EN12-45 is rated 100-240V 47/63Hz and accepts
AC mains power over a range of 90-264V 47/63Hz. Do not connect it to power outside this
range. Damage resulting from incorrect connection is not covered under warranty.
North America: A cable with a NEMA 15-5P plug is provided for use with the EN12 in the USA and Canada.
This approved cable must be used in North America.
Rest of the world: The provided power cable is not fitted with a country-specific plug. Install only a plug
that meets local and or national electrical codes and is suitable for the country's specific requirements.
A 3-prong grounded-type (earthed type) plug must be installed following the plug
manufacturer's instructions. To apply power to the product: In addition to the input, the unit
has a loop through output connection, allowing daisy chaining between multiple EN12s. Do
not exceed 6A total power draw from the power output.
D M X C O N N E C T I O N S ( E N 1 2 )
All DMX Output connections are 5pin female XLR; however, the pin-out on all sockets is pin 1 to shield,
pin 2 to cold (-), and pin 3 to hot (+). Pins 4 and 5 are not used.
Carefully connect DMX cables to the respective ports.
To prevent damaging the DMX ports, provide strain relief and support. Avoid connecting FOH Snakes to the ports
directly.
Certain functions may require adapters (purchased separately), such as a 5-pole XLR male to 5-pole XLR male.
Pin
Connection
1
Com
2
Data -
3
Data +
4
Not connected
5
Not connected
D M X C O N N E C T I O N S ( E N 1 2 - 4 5 )
All DMX Output connections are RJ45; Pin1: DATA+, Pin2: DATA -, Pin7+8; Ground (ESTA Compliant)
Carefully connect RJ45 cables to the respective ports.
To prevent damaging the ports, provide strain relief and support. Avoid connecting FOH Snakes to the ports
directly.
L
Connection
1
Data +
2
Data -
3
Not connected
4
Not connected
5
Not connected
6
Not connected
7
Com
9

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Netron en12 45

Table des Matières