Maintenance - OBSIDIAN CONTROL SYSTEMS NETRON EN12 Manuel D'installation

M A I N T E N A N C E
The Obsidian Control Systems Netron EN12/EN12-45 is designed as a rugged, roadworthy device.
The only required service is occasional cleaning. For other service-related concerns, please contact
your Obsidian Control Systems dealer, or visit www.obsidiancontrol.com.
Any service that is not described in this guide must be carried out by a trained and qualified Obsidian
Control Systems technician.
As any computer, the EN12/EN12-45 requires periodic cleaning. The schedule relies on the
environment in which the controller is operated. An Obsidian Control Systems technician can provide
recommendations if necessary.
Never spray cleaner directly onto the device surface; always spray into a lint-free cloth and wipe it
clean. Consider using cleaning products designed for cellphone and tablet devices for cleaning a
lighting console.
Important! Excessive dust, dirt, smoke, fluid build-up, and other materials can degrade the
performance of the EN12/EN12-45 controller, causing overheating and damage to the unit
that is not covered by the warranty.
Fuse Replacement:
Single fuse in the Line side; the EN12/EN12-45 is protected by a single 1A slow blow
mains fuse in a fuse holder on the back of the device.
Disconnect the product from AC mains power before replacing the fuse as parts of the
product may remain live even if one of the two mains fuses has blown.
14