Indesit DP 2G (IX) Mode D'emploi page 13

To avoid all risk, if the power cable becomes damaged,
it must only be replaced by the manufacturer,
by an authorised service centre, or by a qualified
electrician.
Adaptation to various types of gas (Fig. 5)
Should the appliance be pre-set for a different type of
gas than that available, proceed as follows:
• replace the injectors (Fig. 5) with the corresponding
type of gas to be used (see table "Uses
characteristics").
• to adjust to the minimum, use a screwdriver on the
screw placed on the tap (Fig. 6) after turning the tap
to its minimum position. For LPG (butane/propane)
screw tight
Fig. 6
wok C3 only
Fig. 5
Fig. 6
GB
13