LENCO CR-16 Mode D'emploi page 8

OFF button. The alarm will ring again at the same alarm time
on the following day, or when set to go off based on your Alarm
settings.
SNOOZE FUNCTION
When the alarm source is sounding, press the SNOOZE button to
suspend the alarm and activate the snooze function. The Alarm
will temporarily stop and sound again 9 minutes later but the
ALARM 1 (or ALARM 2) indicator will keep flashing.
Notes:
- This manual snooze operation can be repeated again and
again.
- To turn off the snooze function before it ends, tap the
corresponding ALARM 1 (or ALARM 2) button or the POWER
ON-OFF button. The ALARM 1 (or ALARM 2) INDICATOR will
stop flashing.
LISTENING TO THE RADIO
RADIO TUNING
1. In standby mode, tap the POWER ON-OFF button to turn the
unit "On".
2. The LED DISPLAY will show the radio frequency for about 5
seconds and then revert to normal time display.
AUTOMATIC SEARCH FOR RADIO STATIONS
To automatically search for stations with strong signals, press and
hold the TUNE UP >> or DOWN << button until the frequency
readout on the display begins to scan. Release the button. The
tuner will stop on the first strong station it finds.
MANUAL SEARCH FOR RADIO STATIONS
1. Tap the << or >> button repeatedly to choose your desired
radio station.
2. Tap the VOLUME UP or DOWN button to set the desired
volume level. The volume level reading will appear in the LED
DISPLAY.
Notes:
- Use manual tuning to select weaker stations that might be
E - 7