JessEm Tool Mast R Lift Excel II Manuel De L'utilisateur page 8

Step 1: Flip the Mast-R-Lift Excel II upside
down on a clean flat work surface with the
threaded height adjustment rod facing you.
Step 2: Remove the ¼-20 x 1-1/4" Cap
Screws from the Carriage Nut Cover (Figure
21) and remove the cover and o-ring (Figure
22)
Figure 21
Figure 22
Step 3: Slide the carriage all the way up
to the towards the phenolic table top.
Step 4: Turn the carriage nut clockwise
ensuring when you complete your
adjustment that the slot in the carriage nut
aligns with one of the slots on the
anitbacklash nut.
(Figure 23 )
Figure 23
Step 5: Slide the carriage back up ensuring
the dowel pin in the carriage aligns with the
slot in the carriage nut. (See Figure #24)
Figure 24
Step 6: Place back the o-ring and carriage nut cap
and with the screws you removed in Step 2 (Figure
21) fasten the carriage nut cap securely.
JESSEM TOOL LIMITED WARRANTY
All JessEm products are warranted to be free
from defects in material and workmanship.
JessEm will repair or replace any product which
upon inspection proves to be defective for a
period of (1) year from dated receipt and proof
of purchase. All warranty claims should be
made direct to JessEm Tool Company. Contact
JessEm for a warranty claim return
authorization and instructions to proceed. The
consumer is responsible for shipping costs to
return product to JessEm Tool Company. We
will repair or replace the product at our
discretion and JessEm Tool will return shipment
to you at no charge.
WARRANTY LIMITATIONS
This warranty does not cover:
• Repairs or alterations made or attempted by
anyone other than JessEm Tool Company or
an authorized JessEm service professional.
• Normal wear and tear
• Abuse, misuse or neglect.
• Improper care or maintenance.
• Continued use after partial failure.
• Products that have been modified in any way.
• Products used with improper accessories.
• Premature thread wear due to adjusting
height with electric or cordless drill.