Optional Pvc-Coated Conduit Bending - Greenlee 855GX IntelliBENDER Manuel D'instructions

Operation (cont'd)
Fully Programmed Bending (cont'd)
Steps 7–10 are the same for a 3D bend as for an
offset bend with the following exception: After
making the first bend, you will be instructed to
rotate the conduit by some angle counterclockwise
or clockwise. Clockwise means pushing the bent leg
to the back of the bender while counterclockwise
means pushing the bent leg toward the front of the
bender.
CCW CW
Note: Placing a protractor on the tail end of the
conduit before making the first bend will aid in
knowing how far to rotate the conduit.
7. Press NEXT to proceed or BACK to return to the
previous screen.
8. Place a tape measure and place marks at the dis-
played distances.
9. Press "SAVE" to save the programmed bend to the
bender's local memory; or press "SAVE USB" to
save the programmed bend to a USB thumb drive;
or press NEXT to proceed making the programmed
bend; or press BACK to return to the previous
screen.
10. Load conduit and line up the front of the hook with
the first mark. Press BEND until the bender stops.
The display will show both the stop angle and the
actual bend angle. Unload the conduit and reload
aligning up to the second mark. Press BEND until
the bender stops. Repeat as necessary until the
display shows "BENDING COMPLETE".
Greenlee / A Textron Company

Optional PVC-Coated Conduit Bending

1. Disconnect power to the bender.
2. Position the bending head in the vertical position.
3. Remove the shoe retainer by pulling out on the
detent pin ring, and slide the retainer off the spindle.
4. Pull out and remove the shoe.
5. For 1-1/2" and 2" PVC-coated conduit:
Install shoe and begin bending. No roller changes
are required.
For 1/2" to 1-1/4" PVC-coated conduit:
Proceed to step 6 and refer to illustration below.
6. Remove the 1" roller support and lower the pivot
handle.
7. Install the PVC-coated conduit roller support by
sliding it between the existing rollers from the right
side of the bender and dropping it down so it hooks
Rotation
on the bender frame roller support tubes.
Angle
8. Install 1/2" to 1-1/4" shoe and follow PVC bending
instructions.
15
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
855GX Electric Bender
1/2" to 1-1/4" PVC-Coated Rigid
Roller Support Installation