Yaesu G-1000DXC Mode D'emploi page 6

Controller Front Panel
POWER Switch
Press this switch to turn the controller on to rotate
the antenna. Turn it off when the rotator is not in
use.
LEFT/RIGHT Seesaw Switch
Press the LEFT side of this switch to rotate the an-
tenna counter-clockwise (CCW). Press the RIGHT
side to rotate the antenna clockwise (CW).
PRESET Control and START Switch
Set the PRESET control to the desired antenna head-
ing according to the inner angular scale (0 ~ 90)
around this control, then press the (momentary)
START switch to activate automatic rotation to the
desired heading. You can press the LEFT/RIGHT
switch to abort preset operation.
Note: If you change the rotator starting position to
the 180° (S: South), set the PRESET control to the
desired antenna heading according to the outer an-
gular scale (180 ~ 270) around this control.
Page 4
SPEED Control
Set this control for the desired rotating speed be-
tween approximately 30 and 100 seconds per 360°
revolution.
OVERLAP Indicator
This red LED glows when the antenna is rotated
beyond about 360° (to 450°) from its fully counter-
clockwise position. Check this indicator before ro-
tating the antenna clockwise, and turn the antenna
counter-clockwise to the desired position if the in-
dicator is on.
G-1000DXC/-2800DXC User Manual